Maintenance; Seat Cleaning & Removal; Nozzle Cleaning - brondell S1200-EW Manual De Usuario

MAINTENANCE

SEAT CLEANING & REMOVAL
Unplug the Swash from the power source before cleaning or removing the seat.
Use a soft, damp cloth and mild cleanser (such as dish soap, Simple Green or Windex) to wipe
down the seat. DO NOT scrub or use harsh, abrasive products to clean the Swash. DO NOT use
thinner, benzene, acidic chemicals, chloride, or hydrochloric acid detergent. This may result in
corrosion to the metal parts or discoloration or scratches to the bidet body.
For a more thorough cleaning, you may remove the Swash. To remove the seat, press the Quick
Release button (#11 on Page 9) and slide the seat forward off of the mounting plate and toilet.
NOTE:
• Be cautious of leaving home and beauty products in contact with the bidet seat, the result
of which can be irreversible discoloration. Most stains can be removed using a 1:1 mix of
rubbing alcohol and water and a soft cloth or towel. However, some permanent stains are
the result of substances left on the seat while the seat heater was activated. Be cautious
of home and beauty products (including but not limited to various hair and air freshener
sprays, lotions, body wash, skin tanners, body butters, and oils) that come in contact with
the seat. Wash off any substances that come in contact with the seat as soon as possible.
If necessary, replacement seat parts can be purchased through Brondell customer support.

NOZZLE CLEANING

1. Press the Nozzle Cleaning button on the Auxiliary Control
panel on the side of the Swash. The front wash nozzle will
fully extend. Gently clean the nozzle with a soft cloth or
toothbrush.
2. Press Nozzle Cleaning button again and the front wash
nozzle will retract and rear wash nozzle will fully extend.
Gently clean the nozzle with a soft cloth or toothbrush.
3. Press Nozzle Cleaning button a third time and the rear
nozzle will retract back into the seat. Take care when
cleaning the nozzles not to apply too much pressure to
avoid damaging the nozzle system.
Step 1
29