TECshow NAVIGATOR EXPERT RDM Manual De Usuario página 33

RDM DMX Address Assignments
[RDM DMX Address setup]
This menu allows identifying connected RDM devices
and changing their DMX address assignment.
1. Call the menu item [RDM DMX Address setup].
2. Select the setting [YES] with the PAN wheel to
access RDM functions and confirm with ENTER.
3. The controller starts searching for RDM devices.
The display indicates e.g. "DISCOVER COUNT005"
when five devices have been found.
4. Select the desired device with the PAN wheel. The
display indicates information regarding the device in
the upper line and the corresponding DMX address in
the lower line.
5. Use the TILT wheel to change the DMX address and
confirm with ENTER.
- Any settings changed will be instantly accepted by the
unit itself.
6. Press the SWAP button to indicate the UID (manu-
facturer ID and serial number) of the device in the up-
per line of the display.
7. Press the BLACKOUT button to perform the identify
function for the device. The device will send a status re-
sponse so that it can be properly identified even if there
are multiple identical spotlights.
8. After your settings, return to the main menu level
with ESC.
Regarding RDM
RDM stands for "Remote De-
vice Management" and makes
remote control of devices
connected to the DMX bus
possible. RDM is an extension
of the DMX512 protocol. RDM
is especially useful when the
device is installed in a remote
area. RDM is integrated in
DMX without influencing the
connections. RDM data is
transmitted via the standard
XLR pins 1 and 2 and does
not require a new cable type.
RDM-ready and conventional
DMX devices can be operat-
ed in one DMX line. If DMX
splitters are used, they must
support RDM.
Regardim USB Memory
This unit supports data carriers
with the file system FAT32 and
with a capacity up to 32GB.
• Prior to connecting a USB
memory device, call the system
settings.
• If a data carrier is not recog-
nized at the first try, turn the
controller off and on again.
P. 33
NAVIGATOR EXPERT RDM
ENGLISH VERSION