TECshow NAVIGATOR EXPERT RDM Manual De Usuario página 16

Step 3: Assign the DMX Start
Addresses Manually
It is possible to operate up to 24 spotlights with the con-
troller. However, the fixtures have to be split to the 512
available DMX addresses. Thus, it is reasonable to use only
the DMX channels that the fixtures actually require.
1. Use the FIXTURE buttons at the lower left to select
the first fixture of which the DMX start address is
to be assigned (button lights).
2. The 24 fixtures are split into 3 pages. If necessary,
use the PAGE button to switch between the pages.
The LEDs A, B and C indicate which page's select.
3. This menu item allows adjusting further charac-
teristics. Use the button SWAP to switch between
the options LED A, B or C.
4. Select the option "DMX START ADDR" to assign
the DMX start address. The display indicates "NO
PATCH ADDRESS" in case no assignment was
made yet; otherwise it indicates e.g. "ADR:001".
5. Change the address with the PAN wheel and
press the ENTER button to memorize your set-
ting. To confirm the memory procedure, all LEDs
of the controller flash three times.
P. 16
NAVIGATOR EXPERT RDM
ENGLISH VERSION
Usually the first device is assigned the address 1. The sec-
ond device receives the next free DMX channel as start
address. If the first device requires, for example, 14 DMX
channels, the start address of the second device must be
assigned to the 15th channel.
Proceed according to this scheme, until all spots receive a
start address assigned to the console.
If the display inserts an "!" behind the set start address,
an overlap in the DMX addresses exists. Several spots
then try to access the same DMX address. This is usually
the case, if you have already assigned the start address-
es, yet have not entered the lighting functions and thus
also not the number of channels. To assign the functions
on the console, see the next section. However, if you edit
the lighting functions and channels and an "!" is still dis-
played behind starting addresses, entries are incorrect.