TECshow NAVIGATOR EXPERT RDM Manual De Usuario página 23

Use the FIXTURE buttons at the lower left
1.
to select the fixtures to be assigned to an effect.
- If necessary, use the PAGE button to
switch between the pages.
Call the effect mode with the MOVEMENT button.
2.
3. Select the desired movement or color effect
with the number buttons at the lower right corner.
The corresponding button and the SPEED LED
above the PAN/TILT button light. The selected fix-
tures will begin to perform the movement effect.
- Number buttons 1-9: Create movements
designed for pan and tilt movement of
moving
- Number buttons 10-15: Create color ef-
fects for all kinds of LED spotlights.
4. The parameters of the movements and color ef-
fects can be edited and adapted to your particu-
lar application. For movements, a number of pa-
rameters are available and for color effects, the
running speed
- Movements 1-9: Press the RUN MODE
button to switch between the param-
eters and adjust the values with the PAN/
TILT wheels. Please refer to the right-
hand side for detailed information on the
parameters.
- Color effects 10-15: Use the TILT wheel
to adjust the running speed between 1
and 100 % (ind "Movement Speed ").
Overview of all parameters
Movement Range:
Here you can define for pan and tilt separately,
how large the movement radius of the moving
heads should be (1 to 100%).
heads or scanners.
is adjustable.
Movement Offset:
Here you can enter the midpoint of the pan/tilt
movement. Would you like to see the exact mid-
point without spot movement, then set the
movement radius initially to 0, select your mid-
point, and then enter the desired radius.
- EXAMPLE: Manual entries are dominant
over effects. Color effects can therefore only
be produced, when the corresponding colors are
called via faders. The motion effects will initial-
ly overwrite the manually entered position. If,
however, a position is again called up, it will over
write the motion effect.
Movement Speed:
Here you can enter the running speed of a moving
head for one step of the movement (between 1
and 100 %). A lower value may lead to erratic
movements of the moving head as the fixture
cannot implement the speed adjusted.
Delay Level:
By setting a delay time for the operation of sev-
eral moving heads, you can create waves or other
effects. When set to 0, all moving heads will run in
sync. From the value 1 the effect will be delayed
by a full step, 2 will delay half a step, 3 will de-
lay one-third step, until finally 25 will delay
the fixtures by 1/25 step. A high value is not use-
ful for the operation of a small number of fix-
tures, however, with a large number of fixtures
you can achieve great effects.
NOTE It's necessary to shortly switch the effect
off and on again for the changes to take effect.
P. 23
NAVIGATOR EXPERT RDM
ENGLISH VERSION