Using Carbide-Tipped Blades - Skil TS6307-00 Manual Del Propietário

Tabla de contenido

Idiomas disponibles

Changing the blade

NOTE: Clean the blade of any excess oil

before installation .

1. Turn elevation wheel clockwise until the

blade is up as high as it will go. Remove

table insert (see Removing and Installing

The Table Insert )

2. Insert the open-head hex wrench onto the

arbor shaft (Fig.17). Slowly rotate the blade

by hand until the wrench fully engages

on the two flats on the arbor shaft. While

holding the first wrench, loosen the arbor

nut counterclockwise with the the ring-head

hex wrench .Set ring-head hex wrench

aside and continue to loosen the arbor nut by hand . Remove the arbor nut and outer

washer. Unlock the riving knife release lever by rotating it up (Fig. 18). The blade may now

be removed or installed by sliding it onto or off the arbor shaft.

3. Assemble the inner washer and new blade as shown in Fig.19, making certain that the

TEETH OF THE BLADE ARE POINTING DOWN AT THE FRONT OF THE TABLE.

NOTE: The printing on different saw blades are not always on the same side.

4. Assemble the outer washer and arbor nut as shown in Fig.19. While holding the arbor

shaft with the open-head hex wrench, use the ring-head hex wrench to securely tighten

the arbor nut clockwise (Fig. 18).Rotate riving knife release lever downwards to relock.

5. Install table insert (see Removing and Installing The Table Insert ).

Fig. 18

Ring-Head Hex

Wrench