Look 795 BladeRS Manual página 24

EN
8 - Mount the handlebars, then feed the hoses out
through one of the 2 holes provided to ensure the
smoothest possible connection to the shifter. Before
cutting the hoses, make sure to feed as much of
their length as possible into the handlebars (45mm).
NOTE : For a Shimano build, we recommend routing the hoses through the lower holes on the handlebars.
For a Sram build, we recommend routing the hoses through the upper holes on the handlebars.
9 - Install the front derailleur hanger and tighten
the screws to a torque of 3 Nm. If disassembling/
reassembling, apply a drop of medium threadlocker
(LOCTITE 243™ for example) to each screw. Also
check that the rear derailleur hanger is correctly
tightened to 3 Nm.
Different brake hose routing
10 - Install the groupset according to the
manufacturer's instructions.
11 - Insert grommets on any unused hoses and
openings.
12 - Follow the instructions to finalize the fork
assembly.
EN