Idiomas disponibles
Idiomas disponibles
7. CONNECTION TO THE MAINS
1
. Ensure that mains voltage and frequency are the same as those stated on the rating plate
2.
to the appliance.
Ensure that the supply socket:
rated current as set out on the rating plate;
switch with In = rated value as stated on the rating plate;- differential with Id sensitivity=30 mA. . Ensure
that there is no danger of explosion (AD) in the room. . Make sure the environment is suitable for the
power supply cable provided. The cable of the appliance is H05 VVF, designed for internal use.
the plug in the socket (do not use three-way adapters and reduction adapters) (see fig. 5).
8. CONTROLS
The appliance features controls situated in a protected panel on the front side.
the temperature in the appliance.
3. Heating lamp switch:
to switch on the heating lamps.
cover - Position II to lift - Position O to stop - Position I to lower. Press button
display the temperature set-point, which can be changed by pressing button
"DOWN" (see fig. 6).
9. CHECKING CORRECT OPERATION
Make sure that: 1
. plug is connected; . cover is open; . resistor switch is on (green light lit up);
4.
heating lamps are on; . Check that the set temperature is correct. . Keep the machine away from
5
inflammable material or any danger of explosion. N.B.: Switch on the heating surfaces and heating lamps
with opened plexiglass cover only.
10. CLEANING THE BASIN
1
. Turn off the power switch and pull the plug out of its socket. . Clean the basin with a soft,
SPONGE DO NOT USE WATER. 3
appliance to the power supply.
11. REPLACEMENT OF THE LAMP
1.
2
Turn the appliance off. . Take hold of the lamp's protective grid with both hands then push it towards
the centre and remove from the bottom. . Press the lamp towards one of the two supports in order to
release the other end and then take it off of the lamp set. .
bare hands. Use a piece of paper to take hold of it and replace it. . Refit all parts by following the above
instructions in reverse order (see fig. 7).
12. REPLACING THE MIRROR
1.
Switch off the appliance. . Unscrew the rear support screws. . Replace the mirror and put everything
back in reverse order (see figure 8).
Operator's guide
a)
is properly earthed;
complies with the IEC regulations:- thermal-magnetic
c)
2. Basin resistor switch:
2
. Carefully dry each item with a dry, clean cloth. . Reconnect the
3
2
7
b)
fulfils the requirements of the
4
1. Thermostat: t
to switch on the resistors of the basin.
4. Cover lifting switch: t
8 "SET or P"
9 "UP"
3
6
2
4 Warning:
never handle the new lamp with
5
3
(A)
attached
3
5.
Insert
o adjust
o open and close the
once to
or button
10
DAMP
4
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO
