Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 71 Tuesday, January 31, 2023 5:37 PM
Problem
Oven will not steam
The drain in the water tank may be clogged with hard water scale.
cook (On some
• If this happens, the descaling function must be run before the steam function can be used.
models)
Water pools in the
During steam cooking, the water in the water tank is transferred to the bottom of the
bottom of the oven
oven.
during or after
• It is normal for water to fill the bottom of the oven during or after the Steam mode.
steam cooking (On
• If the water leaves mineral deposits on the oven bottom, remove the deposits with a cloth
some models)
White residue
Using hard water in the water tank can result in hard water scale on the oven bottom.
appears on the oven
• To remove mineral deposits that remain on the oven bottom, use a cloth or sponge soaked
bottom after steam
cooking (On some
models)
The sous vide
This alert sounds when the sous vide module is operated without water in the steam
module beeps during
feeder tank.
operation (On some
• Fill the steam feeder tank to the recommended level before using
models)
Parts & Features
Problem
Oven control beeps
Electronic control has detected a fault condition.
and displays any F
• Turn off the oven function you are using to clear the display and stop beeping. Reprogram
code error.
The oven door is locked because the temperature inside the oven has not dropped
k
is on in the display
below the locking temperature.
when you want to
cook
• Press the STOP button. Allow the oven to cool.
Oven light does not
It is time to replace the bulb or the bulb is loose.
work.
• Replace or tighten bulb. See "Changing the Oven Light" section in this Owner's Manual.
Cooling fan
The fan turns off automatically when the electronic components have cooled
continues to run
sufficiently.
after oven is turned
• This is normal.
off.
Oven will not Self
The oven temperature is too high to set a Self Clean operation.
Clean.
• Allow the appliance to cool and reset the controls.
Oven controls improperly set.
• See the Self Clean section.
A Self Clean cycle cannot be started if oven door is open.
• Close the oven door.
Oven door does not
Oven is too hot.
open after a Self
• Allow the oven to cool below locking temperature.
Clean cycle
or sponge soaked in vinegar.
in vinegar or a weak citric acid solution.
oven. If fault recurs, record fault number and call for service.
- [Case 1 ]
Code: F-9
Cause: Oven not heating (upper oven)
- [Case 2 ]
Code: F-19
Cause: Oven not heating (lower oven)
TROUBLESHOOTING
Possible Cause & Solution
Possible Cause & Solution
71
