Idiomas disponibles
Idiomas disponibles
Connect the fence cable to the terminal with the lightning symbols
The energizer is only protected against moisture if it is properly installed. Shield the energizer
from direct solar irradiation. Do not operate the energizer when it lies on the ground. Set the
energizer up in a location where there is no fire hazard.
Earthing:
Good earthing of the fence is extremely important for trouble-free operation and optimum per-
formance of the energizer; therefore it should be earthed at a preferably moist and overgrown
location.
If the ground is dry and the fence is long, an additional earth conductor with intermediate earths
(every 50 m) should be installed along the fence.
Installation with a 12V rechargeable battery:
Connect the 12V rechargeable battery (red + / black -), ensure clean pole terminals and correct
polarity.
The device will not start if the polarity is reversed.
CAUTION!
Only use rechargeable 12 V batteries; only charge rechargeable batteries with ventilation
in well-ventilated rooms. Disconnect the rechargeable battery from the energizer during
the charging process. The rechargeable battery should be recharged before and after
every use as well as during longer periods of storage (every 2 months) and disconnected
from the energizer.
The energizer has an AUTO-ON function which ensures that as soon as power is con-
nected the energizer starts to operate.
Installation with a 230V/110V mains adapter:
For the operation of 230V power supply only use the mains adapter 47PSU0010FEU/
FUK.
Connect the mains adapter with the energizer, as described in Fig. 3, via the mains connection.
With the mains adapter it is easy to charge a connected 12 V rechargeable battery in parallel
operation.
If the 230 V/110V supply fails, the energizer is then supplied from the rechargeable battery.
Installation with 230V/110V:
Insert the energizer's mains plug into the power socket.
CAUTION!
The energizer has an AUTO-ON function. As such, the energizer starts following connec-
tion to the mains network.
3. Commissioning
Switch on energizer with the push button
ticking of the pulses; the energizer is in operation.
The energizer transmits pulses to the fence and the LED display lights up.
1
. After 1 second, you will hear a rhythmic even
( )
.
3
