cecotec BOLERO 10500 INVERTER A Manual De Instrucciones página 73

4. Pour hot water into the drum and leave it for about 10 minutes.
Reconnect the water inlet hose to the tap.
5.
Please note
1. When resuming use of the washing machine, make sure that the ambient temperature is
above 0°C.
2. If the washing machine is located in a room where it can easily freeze, thoroughly drain
the remaining water inside the drain hose and water inlet hose.
3. Refer to a technician if the washing machine freezes. If the washing machine still does
not work after the above procedure, please contact the official Cecotec Technical Support
Service.
6. TROUBLESHOOTING
PROBLEMS
There's water in the drum
before first use.
The washing machine does
not turn on.
The washing machine leaks.
Strange noise and strong
vibrations.
Washing results are not
satisfactory.
The buttons do not work.
The actual running time
of the programmes does
not correspond to the time
indicated on the display.
POSSIBLE SOLUTIONS
This is normal. It's the result of factory water tests.
Check that the plug is properly connected to the socket.
Check if the tap is open.
Check if the Power button was pressed.
Check if the Start/Pause button was pressed.
Check if the Delay Start function is enabled.
Check and tighten the water inlet hose.
Clean the drain hose and contact the official Cecotec
Technical Support Service.
Check whether the transport bolts have been removed.
Check if the levelling feet are properly adjusted. Check if the
washing machine is installed on a level and solid surface.
Check for metal items inside.
Select a suitable washing programme.
Add the appropriate amount of detergent according to the
instructions on the detergent package.
Check whether the "Child Lock" function is enabled.
Check if the laundry in the drum is evenly spread out.
Check if the water flows in and out properly.
BOLE R O D R E S S CO D E 1 0 5 0 0 I N V ERTER A
BOL E RO D R ES S COD E 1 0 5 0 0 I N V ERTER S TE EL A
ENGLISH
73