What To Do In Case Of A Trouble - EINHELL CH 2750 Manual De Instrucciones

Anleitung Comfort-Heizgeräte 31.10.2001 14:25 Uhr
GB
14. WHAT TO DO IN CASE OF TROUBLE
PROBLEM
The heater suddenly stops generating heat.
The automatic cut-out is activated.
The heater does not start up:
1. The tank is empty.
2. The fuel contains water.
3. The automatic ignition system is not working.
4. The ignition is touching the side of the wick.
Smoke and odor formation:
1. The flame is burning too high.
2. Excessive air intake in the heater.
3. The burner is not completely horizontal.
4. Soot or tar deposits on the wick.
5. Old fuel.
The flame is flickering or going out:
1. The fuel contains water.
2. Soot or tar deposits on the wick.
The wick is burning down too fast:
1. Caution! The fuel you are using is mixed with
unauthorized, liquid, and dangerous fuel.
The wick is difficult to adjust:
1. The fuel contains water.
2. Carbon or tar deposits.
The heater is on fire:
20
Seite 20
SOLUTIONS
Ventilate the room and lower the room temperature.
Wait for about 10 or 15 minutes, then restart the
heater.
Never attempt to restart the heater immediately
after switching it off.
1. Fill the tank with authorized fuel.
2. Empty the tank. Have the wick replaced by your
specialist dealer. Then refill the tank with
authorized fuel.
3. Replace the batteries. Replace the flame spark
plug. Check to see if the ignition wire is torn or
disconnected. See section 12.
4. Turn the wick all the way down with the wick
controller until the spark plug touches the tip of
the wick.
1. Turn the wick down with the wick controller to
reduce the flame.
2. Remove the heater from the draft.
3. Turn the burner back and forth with the burner
knob until it settles in a proper horizontal position
above the wick.
4. See section 11.
5. Empty the tank. Have the wick replaced by your
specialist dealer . Then refill the tank with
authorized fuel.
1. Empty the tank. Have the wick replaced by your
specialist dealer . Then refill the tank with
authorized fuel.
2. Have the wick replaced by your specialist dealer.
See section 11.
1. Empty the tank and clean it out.
Have the wick replaced by your specialist dealer.
Fill the tank with authorized fuel.
1. Empty the tank. Have the wick replaced by your
specialist dealer.
2. Follow the instructions in the operating manual.
Empty the tank. Have the wick replaced by your
specialist dealer.
Call the fire brigade.
Extinguish the flames with a fire extinguisher.
Altenatievly, use blankets and pour water on top
of the blankets. Never pour water directly onto
the heater.