Idiomas disponibles
Idiomas disponibles
4.
ATTENTION!
When lifting the inner panel, the intermediate panel
may stick to the inner panel.
Ensure that the intermediate panel does not fall.
▶
Carefully lift the top section of the inner panel until
the fastening pins come out of the holder.
Lift out the inner panel and set it down carefully on a
5.
flat surface.
Remove the intermediate panel and its holders.
6.
The intermediate panel is not secured using retain-
ing pins but rather using rubber mounts.
Clean the door panels with glass cleaner and a soft
7.
cloth.
13.2 Fitting the door panels
Insert the intermediate panel.
1.
Make sure that the intermediate panel is seated cor-
rectly.
a All holders must lay flat against the outer panel.
a If the Low E symbol can be read on the intermediate
panel, the intermediate panel has been inserted cor-
rectly.
Insert the inner panel.
2.
All four fastening pins must engage in the holders
provided for them.
3.
Remove the locking pins and close the appliance
door.
Note: Do not throw away the locking pins. Store the
locking pins in a secure location. You always require
the locking pins when you remove the door or door
panels from the appliance. If you do not have any lock-
ing pins, you can order these from customer service.
13.3 Detaching the appliance door
If it is particularly dirty, you can remove the appliance
door to clean it more thoroughly.
Open the appliance door fully.
1.
Use the security pins to lock the left- and right-hand
2.
hinges.
The locking pins must be fully inserted into the
holes in the hinges.
Grip the appliance door on either side with both
3.
hands and close it by approx. 30 degrees.
Do not close the appliance door fully. The hinges
could become bent and the enamel could be dam-
aged.
Lift the appliance slightly and pull it out completely.
4.
13.4 Attaching the appliance door
WARNING ‒ Risk of injury!
If the hinges are not secured due to an incomplete
lock, they can snap shut with great force.
If the hinge snaps shut when detaching or attaching
▶
the appliance door, do not reach into the hinge.
Call customer service.
▶
If a door pane or appliance door has not been installed
correctly, this is dangerous.
Make sure that all of the door panes and the appli-
▶
ance door have been correctly fitted before you
switch the appliance back on again.
Grip the appliance door on either side with both
1.
hands.
Slide the hinges into the slots in the appliance.
2.
The notch below the hinges must engage into the
frame of the appliance.
Lower the appliance door downwards.
3.
Remove the locking pins.
4.
Note: Do not throw away the locking pins. Store the
locking pins in a secure location. You always require
the locking pins when you remove the door or door
panels from the appliance. If you do not have any lock-
ing pins, you can order these from customer service.
Appliance door en
17
