Additional Information; Troubleshooting - Sony MDR-DS1000 Manual De Instrucciones

1 Additional Information

Troubleshooting

If you run into any problems using this headphone system, use the following
checklist. Should any problem persist, consult your nearest Sony dealer.
Symptom Cause and remedy
No sound
, Check the connection between the processor and the AV component.
, Check that the connected AV component's optical digital output is set to "ON"
, Turn on the AV component connected to the processor, and start the playback.
, Check that the INPUT SELECT switch on the processor is set to the
, If you connect the processor to an AV component using the headphone jack,
, Raise the headphone volume.
, You are trying to play a DTS audio track on a DVD device that does not
, You are playing back a DVD disc recorded in DTS when DTS digital output
, You are playing back a DVD disc recorded in DTS when the DVD device
Distorted or
, When analogue input is selected, change the ATT switch on the processor to
intermittent sound
(sometimes with
, If you connect the processor to an AV component using the headphone jack,
noise)
, When using DTS audio sources, set the EFFECT switch on the processor to
Low sound
, When analogue input is selected, change the ATT switch on the processor to
, If you connect the processor to an AV component using the headphone jack,
, Raise the headphone volume.
when selecting digital input.
component you want to listen to.
raise the volume level on the connected AV component.
support DTS.
• Either use a DVD device that supports DTS, or select a Dolby Digital or
PCM audio track.
setting for the DVD device (including game machines) is "OFF."
• See the instruction manual of your DVD device, and change the DTS digital
output setting to "ON."
(including game machines) and the processor are analogue-connected.
• Use the digital connection. (Analogue sound may not be output from the
DVD device.)
"–8 dB."
lower the volume level on the connected AV component.
"CINEMA" or "MUSIC" mode (page 13).
"0 dB."
raise the volume level on the connected AV component.
Additional Information
(Continued)
GB
17