YATO YT-82159 Manual Original página 14

PRODUCT CHARACTERISTICS
The tile cutter is used for cutting with spinning diamond cutting discs and allows cutting ceramic materials (e.g., concrete, brick,
gypsum) in a straight line. Thanks to a special switch, the cutter is designed to operate with water cooling. The correct, reliable,
and safe operation of the tool depends on its proper use, therefore:
Read this entire instructions manual before the fi rst use of the tool and keep it for future reference.
The supplier shall not be liable for any damage resulting from failure to comply with the safety instructions and recommendations
specifi ed in this instructions manual.
EQUIPMENT
The cutter is equipped with a cutting disc and a water system connection. Before starting work, the tool requires the preparatory
steps described later in this manual.
TECHNICAL DATA
Parameter
Catalogue No.
Mains voltage
Mains frequency
Rated power
Insulation class
Rated speed
Cutting disc
Outer diameter
Inner diameter
Max. thickness
Spindle thread size
Weight
Noise level
- sound pressure L ± K
pA pA
- sound power L ± K
wA wA
Vibration level a ± K
h
Protection rating
The declared total vibration emission value and declared noise emission value have been measured using the standard test
method and can be used to compare one tool to another. The declared total vibration emission value and declared noise emission
can be used in the initial exposure assessment.
Caution! The vibration emission during tool operation may diff er from the declared value, depending on the manner the tool is
used.
Caution! Safety measures to protect the operator, which are based on an assessment of emission exposure under actual condi-
tions of use (including all parts of the work cycle, such as the time when the tool is switched off or idle and the activation time),
must be specifi ed.
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
O R I G I N A L
14
GB
Unit
[V~]
[Hz]
[W]
[min ]
-1
[mm]
[mm]
[mm]
[kg]
[dB(A)]
[dB(A)]
[m/s 2 ]
I N S T R U C T I O N S
Value
YT-82159
220 - 230
50
1400
II
12000
125
22.2
1.6
M8
3.29
102.60 ± 3.0
113.60 ± 3.0
5.753 ± 1.5
IPX0