Idiomas disponibles
Idiomas disponibles
5
Installation of appliance
5.3 Wall mounting
• Wall must be flat, straight and have the suffi-
cient bearing capacity.
• Depth of drilling holes must comply with the
length of bolts.
• The bolts and dowels provided are suitable for
brick walls. For other construction material (e.g.
drywall, plate, porous concrete), suitable fixing
dowels and nuts shall be used.
(Figure 2)
CAUTION: Before drilling, ensure
A
that there are no power, gas or wa-
ter pipes in the close proximity of the
drilling locations.
Draw a mid location line from the ceiling perpen-
dicular to the lower edge of the hood .
Paste the installing template provided within the
accessories on the surface where the hood is to
be mounted. In doing this operation, observe the
mounting height of the hood (Figure 2).
There is a tab in the middle of the flue connection
plate. Place the middle point of this tab on the line
that is drawn perpendicular to the wall. In doing
this operation, adjust the hood according to the
maximum height (Figure 2). Mark the holes where
Cooker Hood / User Manual
the flue connection plate will be mounted with the
help of a pen (Figure 2/a).
Drill the marked points with Ø6mm drill and insert
2 plastic dowels in the drilled holes (Figure 2/a).
Fix the flue connection plate to the wall with
3,9x22 screws (Figure 2/a).
To assemble the hood body, you can use the A, B,
C, D Ø8 mm drill on the assembly template, and
insert 4.8x50mm plastic dowels at these points.
(Figure 2/b).
2 piece 4.8x50 suspension screw with a clearance
of 5 mm between the screw head and the wall
(Figure 2/b).
(Figure 3)
1. Hanger Plate
2. Hanging Plate Connection Screw
In order to install your hood to the wall, loosen the
screws on the hanger plates mounted on the mo-
tor cabin and pull them up, and then fasten again
(Figure 3/A).
Turn on the suction glass of the hood and remove
the aluminum oil filter.
13 / EN
