Idiomas disponibles
Idiomas disponibles
3. Snap the desired nozzle onto the Quick-Connect collar
until it clicks into place (Fig. 17).
Fig. 17
Quick-Connect collar
To disconnect a nozzle from the spray wand once the cleaning
job is complete:
4. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release water pressure.
5. Engage the safety lock on the trigger handle by pushing
up on the safety lock until it clicks into the slot (Fig. 16).
6. Remove the nozzle by placing your hand over the nozzle
while pulling back on the Quick-Connect collar.
m
WARNING!
Do not make changes to the nozzle while
the trigger is engaged. Doing so could result in damage to the
pressure washer or injury to the user.
Working with Detergents
When cleaning with the pressure washer, some cleaning tasks
can be solved with water alone, but for most tasks cleaning
with detergent allows for more effective dirt removal.
m
WARNING!
Use only detergents specifically designed
for use with pressure washers. DO NOT USE household
detergents, acids, alkaline solutions, bleaches, solvents,
flammable material, or industrial grade solutions. These could
damage the pressure washer. Many detergents may require
mixing prior to use. Prepare the cleaning solution as instructed
on the solution bottle.
1. Remove the cap from the detergent tank and fill the tank
with detergent (Fig. 18).
Fig. 18
Pressure washer
detergent
Nozzle
"Click"
Detergent
tank
2. Install the soap nozzle (black) on the spray wand (Fig. 17).
3. Turn on the pressure washer. Pull the trigger to operate
the unit. The liquid detergent will automatically mix with
water and be discharged through the nozzle.
m
CAUTION!
Always test the detergent in an
inconspicuous area before use.
4. Turn the detergent dial to adjust the suction volume of the
detergent solution (Fig. 19).
Fig. 19
Detergent dial
5. Apply detergent from the bottom to the top of the dry
surface to be cleaned.
NOTE: Wetting the surface first is not recommended as it
dilutes the detergent and reduces its cleaning ability.
6. Allow the detergent to remain on the surface for a short
time before rinsing. Do not allow the detergent to dry on
the surface.
m
CAUTION!
Damage may occur to painted surfaces if
the detergent is allowed to dry on the surface. Wash and rinse
a small section at a time. Avoid working on hot surfaces or in
direct sunlight.
7. When finished using the pressure washer, you must first
drain and rinse the detergent tank. Run the pressure
washer in low pressure until all of the soap is drained from
the detergent tank.
m
CAUTION!
Failure to follow these cleaning instructions
will cause the injection system to become clogged and
inoperable.
Rinsing with the Pressure Washer
1. Turn off the pressure washer and shut off the water supply.
2. Pull the trigger to release water pressure.
3. Engage the safety lock on the trigger handle by pushing
up on the safety lock until it clicks into the slot (Fig. 16).
4. Remove the nozzle by placing your hand over the nozzle
while pulling back on the quick-connect collar.
11
MIN
MAX
