Idiomas disponibles
Idiomas disponibles
9. Tighten the attachment screw (18) for the propeller in an
anticlockwise direction.
10. Remove the preassembled fastening screw (19) and nut
(16) from the wire mesh guard. Keep it ready to hand.
11. Attach the protective front guard (20) with the hook (1) to
the protective rear guard.
NOTE:
Ensure that the holes for the attachment screw in the
front and rear protective grille are aligned one above the
other.
12. Secure the wire mesh guard with the fastening screw (19)
and nut (16).
13. Close the attachment hooks.
Position
The ideal position is a non-slip, flat surface.
Putting into Service
Electrical Connection
•
Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the device.
You can find this information on the nameplate.
•
Connect the device to a duly installed protective contact
socket.
Use
Basic Settings
Set the blower inclination angle before starting the device.
•
Hold the motor housing with both hands and carefully tilt it
towards the desired position until it clicks into place.
WARNING:
• Always remove the mains plug before cleaning the device.
• If you need to remove the safety guard: Always switch the device
off and remove the mains plug.
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or fire.
CAUTION:
•
Do not use a wire brush or any abrasive items.
•
Do not use any acidic or abrasive detergents.
CAUTION:
The tilt angle is approx. 20 degrees.
Operation
Use the push buttons on the front to select the speed settings:
To shut off the device, select the position 0.
Fan setting
You have two options:
•
Stationary
1. Shut off the device.
2. Pull the control knob upwards.
3. Use the carrying handle to place the device into the
desired position.
Oscillating
•
1. Shut off the device.
2. Press the control knob.
NOTE:
The device rotates automatically in the range of
about 90 degrees.
3. To turn off the function, shut off the device and pull the
control knob upwards.
Cleaning
•
Clean the outside of the device with a dry cloth without any
additives.
•
If the device is very dirty wet a cloth with water and then
wipe the device dry once you have finished.
3 fast
2 medium
1 slow
0 off
27
