Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
Installing the architectural frame on the body of indoor unit:
Receiving window for
remote control, the
lamp will not flash
when wired controller
is used
• Orient the panel so the wire harness can properly reach the control box prior to
attaching the panel.
• Temporarily hang the panel with the hook screws.
• Start to thread the corner screws until each screw has started. Position the hook screws facing inside, and finish
tightening the corner screws.
• Lower the body of the indoor unit if the foam gasket does not seal with the frame.
• Wiring of panel: Connect both connections for the display and louver motors.
Side of indoor unit
WARNING
Leaking air could cause moisture to condense on the ceiling surface and
cause water damage if the panel does not seal against the unit.
The unit must be installed level for water to drain from the condensate pan.
31-5000476 Rev. 0
Side of decorated board
Inaccurate board location
(may vary)
Air leakage
Condensing
moisture
Water damage
Any gap is not allowed
15
