Idiomas disponibles
Idiomas disponibles
| EN |
WARNING
1. Read, understand and follow all instructions before operating this device.
2. Do not exceed rated capacity.
3. Use only on hard, level surfaces.
4. Center load on saddle.
5. Use as a matched pair to support one end of a vehicle only. One pair per vehicle only.
6. Jack stands are not to be used to simultaneously support both ends or one side of a vehicle.
7. No alterations shall be made to this device.
8. Failure to heed these warnings may result in personal injury or property damage.
BEFORE EACH USE
1. Inspect stands before each use. Do not use if bent, broken or cracked components are
noticed. Make sure all parts move freely.
2. Check that the products and the application are compatible.
3. Before using this product, read the user's manual completely and familiarize yourself with the
product and the dangers associated with improper use.
4. at the end of use, store the pin in the last hole of the column to avoid losing it. Usually it is
pre-installed.
5. Check the vehicle's jacking points with the vehicle manufacturer or its service manual.
OPERATION
IMPORTANT!
Rated capacity is per pair. Use Only one pair per vehicle. No alterations shall be made to this
device. Do not use adapters or accessories on the saddle or base frame.
1. Adjust saddle height by pulling up the extension tube, then insert the tube support bar
through the hole on extension tube.
2. Ensure that support bar is secure before loading. Insert support bar into the extension tube
far enough to create equal distance of bar extending from the extension tube on both sides.
3. Carefully position stands so that load is centered on stand's saddle.
4. Slowly lower the vehicle onto the stands.
5. Check or ensure that vehicle is secure before working on, around or under. When used to
support vehicle, use wheel chocks to prevent inadvertent movement.
TO LOWER LOAD
IMPORTANT: Be sure all tools and personnel are clear before lowering load.
