Idiomas disponibles
Idiomas disponibles
If you want to stop the Bluetooth
♦
with your selfie stick, for instance, to separate the
devices, press the On/Off button 8 for 2 seconds .
The Bluetooth
charging status LEDs 9 light up and then go off
after about 30 seconds . The Bluetooth
is now turned off .
NOTE
►
Press and hold the On/Off button 8 of the selfie
stick for 2 seconds to turn on the Bluetooth
function . The Bluetooth
approx . 7 seconds .
The charging status LEDs 9 light up and then
go off after about 30 seconds . The devices are
now connected via Bluetooth
to confirm the Bluetooth
smartphone .
Assembling the selfie stick
♦
Screw one of the threads on the mount 2 onto the
thread of the tripod head 3 . You can assemble the
mount 1 vertically or horizontally . Fix the required
position using the fastening screw 4 .
♦
Push the telescopic shaft 5 into the holes on the
selfie stick handle . Turn the telescopic shaft 5 clock-
wise a little until the telescopic shaft 5 clicks into
the selfie stick . The telescopic shaft 5 and the
selfie stick are now connected to each other .
Attaching a smartphone to the selfie stick
♦
Open the mount 1 by pulling the spring clip open .
♦
Place your smartphone into the mount 1 .
♦
Release the clip so that the clip snaps onto your
smartphone . Ensure that your smartphone is firmly
in place in the mount 1 .
♦
Set the vertical tilt angle of the smartphone . Loosen
the fastening screw hinge joint w on the mount by
turning it anticlockwise . Lock the smartphone into
this position by turning the fastening screw hinge
joint w clockwise .
♦
Set the horizontal alignment of the smartphone .
Undo the fastening screw 4 on the mount by turn-
ing it to the right . Turn the fastening screw 4 to the
left to lock the smartphone into this position .
│ GB │ IE
■
28
®
LED 7 flashes 3 times . The
®
LED 7 lights up for
®
®
connection
®
®
. You may have
connection on your
SSP 2600 A1
function
®
