Idiomas disponibles
Idiomas disponibles
Bow-Tie Clip
6.
Remove the bow-tie cotter pin securing the deck stabilizer rod to the deck.
Slide the deck lift rod from the mounting bracket on the deck as shown in
Figure 24.
7.
Carefully remove the PTO cable from the rear of the cutting deck by
removing the bow-tie cotter pin which secures it. Remove the spring from
the deck idler bracket. See Figure 25.
8.
Gently slide the cutting deck (from the left side) out from underneath the
tractor.
SERVICE AND MAINTENANCE
Figure 23
Figure 24
Tires
Never exceed the maximum inflation pressure shown on the sidewall of tire.
The recommended operating tire pressure is:
•
Approximately 10 psi for the rear tires
•
Approximately 14 psi for the front tires
IMPORTANT: Refer to the tire sidewall for exact tire manufacturer's
recommended or maximum psi. Do not overinflate. Uneven tire pressure could
cause the cutting deck to mow unevenly.
Battery
California Proposition 65 WARNING! Battery posts, terminals, and related
accessories contain lead and lead compounds, chemicals known to the State of
California to cause cancer and reproductive harm. Wash hands after handling.
If removing the battery, disconnect the NEGATIVE (Black) wire from its
terminal first, followed by the POSITIVE (Red) wire. When re-installing
the battery, always connect the POSITIVE (Red) wire to its terminal first,
followed by the NEGATIVE (Black) wire.
Jump Starting
Never jump start a damaged or frozen battery. Be certain the vehicles do not
touch, and ignitions are off. Do not allow cable clamps to touch.
1.
Connect positive (+) cable to positive post (+) of your tractor's discharged
battery.
2.
Connect the other end of the cable to the (positive +) post of the jumper
battery.
24
PTO Cable
Figure 25
WARNING
CAUTION
WARNING
