Idiomas disponibles
Idiomas disponibles
V. C O M F O R T A D J U S T M E N T S
TILLER ANGLE ADJUSTMENT (See fi gure 24)
WARNING! Remove the key from the key switch before adjusting the tiller or the seat. Never
attempt to adjust the tiller or the seat while the Travel Scooter is in motion.
WARNING! Prior to operating the scooter, push and pull on the tiller to ensure that the angle
adjustment mechanism is secure. Inspect the tiller adjustment knob and the angle adjustment
mechanism to ensure that they are fully engaged. If there is movement in the tiller, check to
make sure that the tiller adjustment knob is fully tightened.
NOTE: In order to fully lower the tiller, you must fi rst remove the seat and battery pack. Remove the seat by
pulling it straight up and off of the Travel Scooter.
SEAT ROTATION ADJUSTMENT
The seat rotation lever, located on the right side of the seat base, secures the seat into several positions. See fi gure 25.
1. Pull up on the seat rotation lever to disengage the seat.
2. Rotate the seat to the desired position.
3. Release the lever to secure the seat into place.
ARMREST WIDTH ADJUSTMENT
The armrest width can be adjusted inward or outward.
1. Loosen the armrest adjustment knobs. See fi gure 25.
2. Use the attached ring to pull and remove the detent pins.
3. Slide the armrests in or out to the desired width.
4. Align the adjustment holes on the seat frame and armrest, then reinsert the detent pins.
5. Tighten the armrest adjustment knobs.
NOTE: Pivot the armrests upward to aid in getting onto and off of your Travel Scooter.
Figure 24. Tiller Adjustment Knob
Travel Scooter Series
IDENTIFICATION KEY
1. Armrest Adjustment Knobs
2. Detent Pins
3. Seat Rotation Lever
Figure 25. Seat Adjustments
27
