Pride Mobility Travel Scooter AAP4 Manual De Usuario página 26

Idiomas disponibles

Idiomas disponibles

 Move the tiller to the center position to drive straight ahead.
 To stop, slowly release the throttle control lever. The electronic brakes will automatically engage when your
Travel Scooter comes to a stop.
 If equipped with iTurn Technology™ , ensure your travel scooter is pivoting properly in both directions by
observing the rear wheel on the side of the scooter you are turning to.
NOTE: If equipped with iTurn Technology™, rapidly turning the tiller fully to one side and then the other side
may result in the Travel Scooter to not operate as expected and/or a controller fault. To reset the controller,
turn the tiller to the center position, then turn the key to the off position, wait 5 seconds and then turn the key
to the on position.
NOTE: Your Travel Scooter's reverse speed is slower than that of the forward speed you preset with the speed
adjustment dial.
GETTING OFF OF YOUR TRAVEL SCOOTER
1. Bring your Travel Scooter to a complete stop.
2. Remove the key from the key switch.
WARNING! Never attempt to get onto or off of your Travel Scooter without fi rst removing the
key from the key switch. This will prevent the Travel Scooter from moving if accidental throttle
control lever contact is made.
3. Disengage the seat rotation lever and rotate the seat until you are facing toward the side of your Travel Scooter.
4. Make certain that the seat is secured into position.
5. Carefully and safely get out of the seat and stand to the side of your Travel Scooter.
6. You can leave the seat facing to the side to facilitate boarding your Travel Scooter next time.
POWER DOWN TIMER FEATURE
Your Travel Scooter is equipped with an automatic power down timer feature designed to prevent your Travel
Scooter from moving if left unattended. If you mistakenly leave the key in the "on" position but do not use your
Travel Scooter for approximately 20 minutes, the Travel Scooter's controller shuts down automatically. Although
the controller is shut down, power will still be supplied to the Travel Scooter's electrical system.
If the power down timer feature takes eff ect, perform the following steps to resume normal operation.
1. Remove the key from the key switch.
2. Reinsert the key and power up your Travel Scooter.
26
I V. O P E R AT I O N
Travel Scooter Series
loading