Oki LE840 Guia Del Usuario página 35

2. PRINTER SETUP
2.6.2 Parameter Setting
(Cont.)
NOTE:
Since detecting the remaining
ribbon length has a margin of
error, use the specified length as
a guide.
NOTE:
The type specified by the
command may differ from the
actual mode, depending on the
status of this parameter. Also,
the data transmission method is
slightly different.
For details, refer to the External
Equipment Interface Manual.
(10) WEB PRINTER
Select whether to use the printer as a web printer.
When the web printer is enabled, the status of the printer connected to
a network can be monitored through the web browser.
 OFF
 ON INTERNAL
 ON EXTERNAL
(11) RBN NEAR END
Select the remaining ribbon length when the ribbon near end is
detected.
 OFF
Ribbon near end is not detected.
 30m
Ribbon near end is detected when the remaining
ribbon is 30-m long. (Equivalent to ribbon diameter
of 38 mm)
 70m
Ribbon near end is detected when the remaining
ribbon is 70-m long. (Equivalent to ribbon diameter
of 43 mm)
(12) EX.I/O
Select the type of expansion I/O interface operating mode. This
parameter needs to be set depending on the expansion I/O control
specification of the device to be connected via the expansion I/O
interface.
 TYPE1
Standard mode
 TYPE2
In-line mode
(13) LBL/RBN END
Select the operation to be performed when a label end or ribbon end is
detected.
 TYPE1
When a label/ribbon end is detected in the middle of
printing, the printer immediately stops printing.
 TYPE2
Selectable only when the ribbon saving function is
not activated.
When a label/ribbon end is detected in the middle of
printing, the printer prints the half-finished label as
far as possible, and stops when the next label is at the
home position.
(14) MAXI CODE
Select the Maxicode specification.
 TYPE1
Compatible with the current version
 TYPE2
Special specification
E2-21
Disables web printer function
Enables web printer function (using internal
memory)
Enables web printer function (using an external
usb memory)
2.6 Printer Setting