Seca 780 Manual Del Usuario página 8

You must check before connecting the
equipment whether the AC voltage gi-
ven on the mains unit matches the local
mains voltage given on your electricity
meter.
• Carefully tilt the scale to one side so that
the base of the scale is accessible.
• Plug the latching plug of the mains unit
into the connection socket in the base of
the scale.
• Stand the scale back up again.
• Connect the mains unit to a power
socket.
• If the digital display now comes on, switch
off the scale using the START
key.
How to weigh properly ...
Start scales and set to zero
Press the green Start button: the display fi rst
shows for 1 sec., then the full display
for 1 sec., then automatically
The scales are now ready to use. If when
unladen the scales should not show
exactly , but for example
, they can be re-set to
8
ching off and back on again using the green
Start key.
To switch off the scales, simply press the
Start key.
Weighing
Is the display on zero? Then you can start!
Simply stand on the scales and keep still.
The display now shows your weight.
Switching between kg/lbs/sts
If you want weight displayed in a unit other
than the one displayed, then press the kg/lbs
switch on the display surface after
switching the scales on or during
weighing. The unit selected is shown by the
indicator "kg", "lbs" or "sts" on the right-hand
side of the display.
In order to display stones, you must keep
the key for switching between kg/lbs/sts
depressed for at least 2 sec onds.
Pressing the key briefl y takes you back to a
kg display. Hol ding it down for a long time (at
least 2 seconds) switches you between lbs
and sts.
.
or
by swit-
The scales always start with the unit they
were displaying when switched off.
Automatic
switch-off/economy mode
The scale automatically detects whether it is
being operated on rechargeable
batteries alone or whether it is connected to
the mains.
● With rechargeable battery operation:
automatic shut-down after 30 seconds.
● With mains operation: shut-down only via
keypad.
Temperature changes
If the scales are exposed to a severe change
in temperature either before or
during use, then to avoid small
measurement errors, you should wait 15
minutes for the scales to adapt to the new
temperature. A fl ashing display indicates that
the scales are being operated during
temperature changes which are too
severe.
Cleaning
Clean the outside of the scale as required
using a domestic cleaning agent or a
commercially available disinfectant. Follow
the manufacturer's instructions.
kg/lbs/sts