Connection Of Control Panel; Connection Of Motor - THERMEx ES 900 Instrucciones

60 THERMEX ES 900

CONNECTION OF CONTROL PANEL

This PCB can be used with various types of control panels. It is important that the control panel is con-
nected properly and the PCB is adjusted to the selected control panel in order for the control panel to be
able to function.
When connecting the control panel, it is important that the connectors from the ribbon cable are turned
the right way round, both on the PCB and control panel.
The setting of the rotary DIP switch for the control panel must also be set correctly in order for the con-
trol panel to be able to function. The setting must be made according to the type of control panel used:
SETTING OF ROTARY DIP SWITCH
0
1
2
3
4
5
6
7
8
9
NOTE: If the settings on the rotary DIP switch are changed, the power must be switched off for 60 se-
conds and reconnected before the settings are saved.

CONNECTION OF MOTOR

This PCB can be connected to various types of motors and the connection of the ES 900 varies according
to the type of motor used. In addition to connecting the motor correctly, the PCB must also be set accor-
ding to the type of motor selected.
The connection is carried out according to the wiring diagram, which can be found in the "Wiring dia-
gram" on page 58.
The setting of the rotary DIP switch for the type of motor must also be set correctly in order for the hood
to be able to function. The setting must be made according to the type of motor used:
All manuals and user guides at all-guidesbox.com
TYPE OF CONTROL PANEL
Foil control panel
Glass touch
Push buttons
M P550193900017012018