Idiomas disponibles
Idiomas disponibles
CHAIN MAINTENANCE
See Figures 33 - 35.
WARNING:
Remove the battery pack and make sure the chain
has stopped before you do any work on the saw.
Use only low-kickback chain on this saw. This
fast-cutting chain will provide kickback reduction
when properly maintained.
For smooth and fast cutting, chain needs to be
maintained properly. The chain requires sharpen-
ing when the wood chips are small and powdery,
the chain must be forced through the wood dur-
ing cutting, or the chain cuts to one side. During
maintenance of your chain, consider the following:
Improper filing angle of the side plate can
increase the risk of a severe kickback.
Raker (depth gauge) clearance.
Too low increases the potential for kickback.
Not low enough decreases cutting ability.
If cutter teeth have hit hard objects such as nails
and stones, or have been abraded by mud or sand
on the wood, have service dealer sharpen chain.
NOTE: Inspect the drive sprocket for wear or dam-
age when replacing the chain. If signs of wear or
damage are present in the areas indicated, have the
drive sprocket replaced by a Ryobi Service dealer.
MAINTENANCE
CHECK FOR WEAR
OR DAMAGE
TOP PLATE
RIVET HOLE
28 - English
RAKER CLEARANCE
.025 in.
CUTTING
CORNER
DEPTH GAUGE
HEEL
TOE
GULLET
Fig. 33
Fig. 34
SIDE PLATE
Fig. 35
