Idiomas disponibles
Idiomas disponibles
5.2 Electrical connection
AC Connection.
Make sure that the voltage and capacity of the power supply
cable conform to the data shown on the plate located under the
protective cover.
The power supply cable plug and the wall socket must be of the same
type and conform to the current electrical system regulations. Make
sure that the power line is adequately grounded.
On the power line, install an all-pole disconnect switch with minimum
contact gap of 3mm located at an easily accessible position near the
appliance.
Do not use reducers, adapters or shunts.
If the power cable is to be replaced, the wire section on the new
cable must not be less than 0.75mm
mind that the end tube connected to the appliance must have the
ground wire (yellow-green) at least 20mm longer.
Use only H05V2V2-F cable or similar which has a maximum
temperature of 90℃. Any replacement needed should be carried out by
a specialized technician who should make the mains connections
according to the following diagram.
L=brown
N=blue
=yellow-green
2
(3x0.75cable), bearing in
6
