Idiomas disponibles
Idiomas disponibles
8． TROUBLESHOOTING
Problems
It won't fire
There is a warning tone when
ignition
Gas leak
Unstable flame
Soft and yellow flame
The flame escapes from the
dire hole or flameout is with
fulmination
Few flames
The flame isn't in uniform
length and the flame is yellow
The flame accidentally goes
red
Problem Cause
Problem Solution
Air is mixed into the gas pipe
The rubber tube bends or flattens
Ignition device and insulation point is
dirty an damp
Safety valve doesn't open
The battery is out of use; the battery
doesn't touch well; or the battery is up
side down
There's problem with the ignition
device or the ignition pin is not in the
right position
The battery is low
The rubber tube cracks or breaks
The rubber tube joint doesn't connect
well with rubber tube or other tube
Whether the LPG is used up
The throttle is not properly adjusted,
and the air is insufficient
The throttle is not properly adjusted,
and the air is insufficient
Injector or stopcock is jammed
Fire lid is not properly covered, and
there' s charcoal other dirt stuffing the
fire hole
Under a certain climate, the gas is with
much humidity
Problem Solution
Firstly turn off the knob, and then open
the general gas valve
Ignite repeatedly until the air is
absolutely discharged
Unfold or change the rubber tube
Clean it with a dried cloth
Press an turn the knob to intense fire,
make sure the hob is fired and keep on
pressing for 3 to 4 seconds
Change the battery or refix the battery
Ask a professional technician for
maintenance
Change the battery
Change the rubber tube
Check the air-tightness of the gas tube
and set it properly
Change into a new bottle of LPG
Gradually enlarge the throttle until the
flame turns normal blue
Gradually enlarge the throttle until the
flame turns normal blue
Use a iron wire to dredge the injector or
the valve core
Make sure that the fire lid is on the right
position ; get rid of the dirt in the fire
hole
The flame turns red because there's
calcium in water, so don't worry about it
16
