5. Using the Equipment
1. Power on the device connected to the Transmitter Box and check
that it is set to Output Video.
2. Connect the 10m Neutrik cable connector to the Neutrik wall plate.
Make sure that the Neutrik symbol is on the top.
3. Connect the other end of the Neutrik cable to the transmitter box.
4. Coil excess cable and secure it with the hook and loop tape on the
bracket
5. The Power LED on the Transmitter Box will illuminate once it is
connected.
• When connected, video will stream in approximately 30 seconds.
• If there is not an available source for SDI, DVI, or VGA, there will
not be a video signal.
• A solid blue screen appears for an SV connection, even if there is
no source video.
6. To disconnect the Neutrik cable from the wall plate, hold the
connector then squeeze and pull to disengage.
10
All manuals and user guides at all-guides.com