Idiomas disponibles
Idiomas disponibles
Installation and Connection
Parts for Installation and
Connection
Mounting screw
(5 × 20 mm (
7
/
×
13
/
in)) (4)
32
16
This parts list does not include all the package
contents.
Installation
Installing the Amplifier
• Mount the amplifier either inside the trunk (boot)
or under a seat.
• For your safety, choose a mounting location that
will not interfere with any driving operations.
• Do not install the amplifier near the heater, in
areas that get exposed to direct sunlight, or
subject to high temperature.
• Do not install the amplifier under a floor carpet
where the heat dissipation from the amplifier will
be considerably impaired.
• Avoid installing the amplifier in areas subject to
rain, moisture, dust and dirt.
Mounting the amplifier
1
Place the amplifier on your selected
mounting location, then mark the position
of the 4 screw holes on a mounting board
(not supplied).
2
Drill a 3 mm (
1
/
in) pilot hole at each mark
8
and mount the amplifier onto the board
with the mounting screws .
The mounting screws are 20 mm (
long, so make sure that the mounting board is
thicker than 20 mm (
Hex key (2.5 mm (
3
/
32
13
/
in)
16
13
/
in).
16
in)) (1)
Changing the heat sink cover direction
The direction of the heat sink cover can be changed
according to your preference.
1
Slide the cover forward, then lift to remove
it.
2
Rotate the cover to your desired direction.
3
Align the cover to the catches on the
amplifier, then slide the cover back until it
clicks into place.
7
EN
