Turning On/Off - Mitsubishi Electric Mr.SLIM PKA-A12HA6 Manual De Instrucciones

9. Operation Manual for IR wireless remote controller
9.2. Operation

9.2.1. Turning ON/OFF

2
COOL
5
6
1
2
<To Start Operation>
Press the ON/OFF button 1.
• The ON lamp 1 and the display area come on.
<To Stop Operation>
Press the ON/OFF button 1 again.
• The ON lamp 1 and the display area go dark.
Note:
Even if you press the ON/OFF button immediately after shutting down the op-
eration is progress, the air conditioner will not start for about three minutes.
This is to prevent the internal components from being damaged.
9.2.2. Temperature setting
To decrease the room temperature:
button 3 to set the desired temperature.
Press
The selected temperature is displayed
To increase the room temperature:
button 3 to set the desired temperature.
Press
The selected temperature is displayed
• Available temperature ranges are as follows:
Cooling/Drying: 19 - 30 °C, 67 - 87 °F
Heating: 17 - 28 °C, 63 - 83 °F
Automatic: 19 - 28 °C, 67 - 83 °F
• The display 4 fl ashes either 8 °C - 39 °C, 46 °F - 102 °F to inform you
if the room temperature is lower or higher than the displayed tempera-
ture. (This display does not appear on the wireless remote controller.)
9.2.3. Fan speed setting
Press the Fan Speed button 5 as many times as necessary while the
system is running.
• Each press changes the force. The currently selected speed is
shown at 5.
• The change sequence, and the available settings, are as follows.
FAN SPEED
4-speed
Speed 1 Speed 2
+
Auto
3-speed
Speed 1
+
Auto
3
˚F
7
3
5
6
7
3
.
3
.
Display
Speed 3 Speed 4 Auto
Speed 2 Speed 3 Auto
9.2.4. Airfl ow direction setting
<To Change the Airfl ow's Up/Down Direction>
With the unit running, press the Airfl ow Up/Down button
• Each press changes the direction. The current direction is shown at
• The change sequence, and the available settings, are as follows.
Remote controller
Swing
Auto
Wired type
Swing
IR Wireless
remote controller
9.3 Timer
COOL
1
Press the or button (TIMER SET).
• Time can be set while the following symbol is blinking.
OFF timer: A is blinking.
ON timer: A is blinking.
2
Use the and buttons to set the desired time.
3
Cancelling the timer.
To cancel the OFF timer, press the
To cancel the ON timer, press the
• It is possible to combine both OFF and ON timers.
1
• Pressing the ON/OFF button of the remote controller during timer
mode to stop the unit will cancel the timers.
• If the current time has not been set, the timer operation cannot be
used.
6
as necessary.
Display
1 2 3 4 5
1 2 3 4
button.
button.
6
.
9