Getting Started; Setting The Time; Alarm Clock - Hama 00176940 Instrucciones De Uso

4. Getting Started

4.1 Inserting the batteries
Open the battery compartment (7) and remove the contact
breaker. Replace the battery compartment cover.
4.2 Replacing the batteries
Open the battery compartment (7), remove and properly
dispose of the dead batteries and insert two new AAA
batteries with the correct polarity. Replace the battery
compartment cover.
5. Operation
Note
• Switch off the clock if it is not working as usual.
• If the display or sound is weak, the battery will need
to be replaced.
Note – Input
• Hold down the SET button (6) to select the values
faster.
• When the clock is switched on, it displays the time
12:00.
• An acoustic signal indicates that the product is ready
for use.
• Turn the alarm clock to switch between the following
modes:
- Temperature indicator (1)
- Date/time display (2)

- Alarm clock (3)

- Timer (4)

5.1 Setting the time

Each time the display mode is changed, a signal tone
sounds. At the same time, the positional sensor of the
product produces a low mechanical noise.
• In the Date/Time position (2), press the MODE button (5)
so that the time begins to flash.
• To select the individual values, press the SET button
(6) and confirm each selection by pressing the MODE
button (5).
• Press the MODE button (5) immediately to adopt the set
value displayed and skip ahead.
• Setting range: hours: 1-12, minutes: 0-59, months: 1-12,
days: 1-31, years: 2000-2099.
• When you set the date, the day of the week (MON to
SUN) changes accordingly. (The current day of the week
flashes).
5.2 Alarm clock
Setting the alarm time
• In the Alarm Clock position (3), press the MODE button
(5) so that the alarm time begins to flash.
• To select the individual values, press the SET button
(6) and confirm each selection by pressing the MODE
button (5).
• Press the MODE button (5) immediately to adopt the set
value displayed and skip ahead.
• Setting range: hours: 1-12, minutes: 0-59.
Enabling/disabling the alarm
• Enable the alarm clock by pressing the MODE button (5)
three times. This is indicated by the bell icon.
• Disable the alarm clock by pressing the MODE button
(5) once more.
• Press any button to stop the alarm signal.
3