Idiomas disponibles
Idiomas disponibles
Accessories
Check to make sure you have the following accessories before disposing of the packing material.
³
Remote Control
For U.S. models: For optional accessories, please access our web site at: www.hitachi.us/tv
CANADA only: For optional accessories, please access our web site at: www.hitachi.ca/tv
CAUTION:
1.
2.
3.
³ Remote Control Unit CLU-4372A
(Part No. HL02402).
· Simple Remote Control Unit CLU-123S
(Part No. HL01864)
» Two "AA" size, 1.5V batteries
¿ Two "AAA" size, 1.5V batteries
REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT
1.
Open the battery cover of the remote control by pushing down and sliding the back cover off.
2.
Insert two new "AA" and "AAA" size batteries for the remote control and Simple Remote Control. When replacing
old batteries, push them towards the springs and lift them out.
3.
Match the batteries to the (+) and (-) marks in the battery
compartment.
4.
Insert the bottom of the battery, the (-) side, into the battery
compartment first, push towards the springs and insert the
top of the battery, the (+) side, into place. Do not force the
battery into the battery compartment.
5.
Replace the cover.
CAUTION: Do not insert batteries with '+' and '-' polarities reversed as this may cause the batteries
to swell or rupture resulting in leakage.
4
·
´
Simple Remote
GUIDE
CH +
VOL +
VOL -
SELECT
MUTE
FAV CH
CH -
MENU
INPUTS
EXIT
POWER
¶
»
Two "AA" size,
1.5V batteries
¿
Two "AAA" size,
º
1.5V batteries
Ceiling mounting is not recommended. Mounting the panel on the ceiling does not
provide adequate ventilation for the electronics or proper support for the front glass
panel. This plasma television product is designed for a maximum tilting angle of 45
degrees from vertical.
This stand for use only with Hitachi P50X901.
capable of resulting in instability causing possible injury.
The wall mount unit for the 50" model is WM07S and for the 60" model is WM07L.
Please see page 7 for important information related to the wall mount. The Wall Mount
unit is an optional accessory (Not Included).
´ Power Cord (Part No. EV01841).
² Two IR Blaster cables (Part No. EY01641).
¶ Power Swivel Table Top Stand (Part No. QJ03754 P50X901 only)
Optional Fixed Tabel Top Stand (Part No. STF0760 P60X901 only)
CH 3
º Power Swivel Cable (Part No. EW08433 P50X901 only).
¾ Wire clamp
²
2 IR Blaster Cables
Power Cord
Power Swivel Table Top Stand
(P50X901 model only)
Power Swivel Cable
(P50X901 model only)
Use with other apparatus is
BOTTOM VIEW
(Remote Control)
Lift up on tab to
remove back cover.
Lift up on tab to remove back cover.
Optional Fixed Tabel Top Stand
(Part No. STF0760 P60X901 only)
CH 3
¾
Wire Clamp
.
BOTTOM VIEW
(Simple Remote Control)
Lift up on tab to
remove back cover.
