Idiomas disponibles
Idiomas disponibles
The Remote Control for Set-Top-Box/Satellite Receiver Functions
OPERATING THE PRECODED FUNCTION FOR
YOUR SET-TOP-BOX/SATELLITE RECEIVER.
This remote is designed to operate different types of
set-top-box/satellite systems. You must first program
the remote to match the remote system of your set-
top-box/satellite systems (refer to pages 42-43 for pre-
codes).
1. Turn ON your set-top-box/satellite systems.
2. To switch to set-top-box/satellite (SAT) pre-coded
mode, use the SOURCE SELECT button on the
remote control to position the LED light to the
corresponding selection SAT/CBL.
Hold down the SOURCE SELECT button on the
3.
remote and enter the four digit preset code that matches
your set- top-box/satellite receiver as shown on page
42-43. Release the SOURCE SELECT button. The
indicator light will flash 3 times if the code was accepted.
4.
Aim the remote at the set-top-box/satellite receiver
and press the POWER button. The remote will turn
off your set-top-box/satellite receiver when the
correct four digit preset code is entered. When this
occurs, the remote control is programmed for your
set-top-box/satellite receiver.
box/satellite receiver does not turn off, try a
different four digit preset code.
5. The remote will now control your set-top-box/
satellite receiver.
NOTE: 1. If your set-top-box/satellite receiver
cannot be operated after performing the
above procedures, your set-top-box/
satellite receiver code has not been
precoded into the remote.
2. In the unlikely event that your set-top-
box/satellite receiver cannot be operated
after performing the above procedures,
please consult your set-top-box/satellite
receiver operating guide.
3. The remote control will remember the
codes you have programmed until the
batteries
are
remote control.
batteries repeat the entire programming
procedure as stated above.
If the set-top-
removed
from
the
After replacing the
MY Satellite RECEIVER/
SET-TOP-BOX CODE IS:
NOTE: Refer to instruction manual of the Set-Top-
PRECODED SET-TOP-BOX/SATELLITE
RECEIVER buttons
These buttons transmit the chosen pre-coded
set-top-box/satellite codes :
-Power
-Cursor & Select
-Menu
-Info
-Exit
-Channel Up & Down
-Guide
-Last CH
EXCLUSIVE TV buttons
These buttons are for operating the TV :
-Day/Night
-CC
-Aspect
-Vol Up & Down
-PIP
-Pause
Box/Satellite Receiver for operation of the
buttons exclusively for the Set-Top-
Box/Satellite Receiver.
-Number PAD
-Enter, Dash
-Mute
-Inputs (Only if
programmed, refer
to page 40).
37
