Hilti Nuron DSH 600-22 Manual De Instrucciones Original página 19

5.4 Installing cut-off wheel
WARNING
Risk of injury and damage. Damaged cut-off wheels may break.
▶ If the cut-off wheel has been subjected to an impact, check the disc for damage and replace it if
necessary.
▶ Never use cut-off wheels that are damaged, run untrue or vibrate.
▶ Don't use synthetic resin-bonded fiber-reinforced cut-off wheels which have exceeded their use-by date
or already softened due to water absorption.
CAUTION
Risk of injury and risk of burns! Cut-off wheels become hot when in use and can have sharp edges that
lead to injuries.
▶ Wear protective gloves for installing, removing and adjusting the accessory tool or other components,
and during troubleshooting operations.
Install only the clamping flange that is suitable for the cut-off wheel used. The outside diameters are
stated in the technical data.
Clamping flanges specially designed for diamond cut-off wheels bear the following wording by way of
identification: "ONLY FOR DIAMOND WHEELS".
1. Remove a mounted dust extraction module (accessory). → page 14
2. Clean all clamping and centering surfaces on the cut-off saw and the cut-off wheel.
3. Check that the mounting flange and the clamping flange are correct for the cut-off wheel.
▶ Change the mounting flange if necessary.
4. Position the cut-off wheel flush and centered on the mounting flange.
▶ The cut-off wheel's direction of rotation matches the direction-of-rotation arrow.
5. Position the clamping flange flush and centered and install the securing screw.
6. Insert the locking pin into the hole in the belt cover.
7. Gently turn the cut-off wheel until the locking pin engages.
8. Tighten the securing screw with the assembly tool.
Technical data
Tightening torque (securing screw)
9. Remove the locking pin.
After installing a new cut-off wheel, start the cut-off saw and allow it to run without load at full
speed for approx. 1 minute. Check for roughness in operation or vibration; if a cut-off wheel is
damaged it will generally break during this test run.
5.5 Removing the cut-off wheel
WARNING
Risk of injury and damage. Damaged cut-off wheels may break.
▶ If the cut-off wheel has been subjected to an impact, check the disc for damage and replace it if
necessary.
▶ Never use cut-off wheels that are damaged, run untrue or vibrate.
▶ Don't use synthetic resin-bonded fiber-reinforced cut-off wheels which have exceeded their use-by date
or already softened due to water absorption.
1. Remove a mounted dust extraction module (accessory). → page 14
2. Insert the locking pin into the hole in the belt cover.
3. Gently turn the cut-off wheel until the locking pin engages.
4. Slacken the securing screw with the assembly tool.
5. Remove the securing screw, clamping flange and cut-off wheel.
6. Remove the locking pin.
*2284138*
3
2
2284138
20 Nm ... 30 Nm
(15 ftlb ... 22 ftlb )
f f
English 13