Idiomas disponibles
Idiomas disponibles
English
CONNECTING POWER TOOL (Fig. K, L)
1. Make sure the control switch 3 is in the 'Off'position
and the power supply is not connected.
2. There are 2 options for the next step.
Option 1:Connecting the tool to the vacuum rst,
then connect the power supply and turn on/off
control switch 3 to the ON position ( I ), at this time
3
the vacuum cleaner will start working.
Option 2:Connecting the tool to the vacuum rst,
then connect the power supply and turn on/off
control switch 3 to the ON position ( I I ), at this time
3
the power tool can start to use.
WARNING:
Use the vacuum cleaner's socket outlet
only for connection of an external power tool. The vacuum
cleaner is automatically switched on and off via the
connected power tool.
The connected load of the power tool may not exceed the
maximum connected load PA of the vacuum cleaner's
socket outlet. Please also observe the operating instructions
and safety warnings of the power tool being connected to
the socket outlet of the vacuum cleaner.
RECOMMENDATION:
cleaner via a residual current device (RCD) with a rated
residual current of 200mA or less.
Please ensure that the power tool switch is in the 'Off'
position before connecting the tool to the vacuum.
After switching off a power tool connected to the vacuum
cleaner's socket outlet, the vacuum cleaner will run on for
approx. 15 seconds and then automatically switch off.
BLOWING FEATURE (Fig. C)
WARNING:
To avoid injury to bystanders, keep
them clear of blowing debris.
The vacuum contains a blowing feature. It has the
capability to blow sawdust and other debris. It can
be used to blow dust and debris out of garages or off
patios and driveways. Follow the steps below to use
the vacuum as a blower.
1. Locate blowing port on the vacuum.
2. Insert one end of the hose into the blowing port.
3. Turn vacuum "ON".
STORAGE (Fig. A)
1. Empty dust tank, refer to
instructions.
2. Clean the vacuum inside and outside. refer
to CLEANING.
3. Clean or replace lters, refer to FILTER.
4. Store the hose and the power cord, as
shown in the
Fig.
A. Place the appliance in
a dry room and secure it from unauthorized use.
3
Always operate the vacuum
TO EMPTY DUST TANK
OPTIONAL ACCESSORIES
WARNING:
Since accessories, other than those
offered by D
WALT, have not been tested with this
E
product, use such accessories with this appliance
could be hazardous.
To reduce the risk of injury, only D
recommended accessories should be used with
this product.
CLEANING
To keep the wet/dry vacuum looking its best, clean
the outside with a cloth dampened with warm water
and mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water and mild
soap.
3. Wipe out with dry cloth.
TROUBLESHOOTING
:
WARNING
TO REDUCE THE RISK OF INJURY FROM
MOVING PARTS AND/OR ELECTRICAL SHOCK,
TURN POWER SWITCH OFF AND DISCONNECT
GROUNDED PLUG FROM ELECTRICAL OUTLET
BEFORE PERFORMING TROUBLESHOOTING
CHECKS.
Minor problems often can be xed without calling
customer service.
20
WALT
E
