Oster Osterizer 250-22 Manual De Instrucciones página 3

K Y
N OW I N G O U R
C
OVER
The cover for your OSTERIZER ® Blender
consists of two parts, the plastic feeder cap
(1) and the vinyl cover (2) . The cover is
self-sealing, and is made of vinyl which is
resistant to absorption of odors and stains.
The feeder cap is removable for use as a
measuring cup and provides an opening
for the addition of other ingredients.
C
ONTAINER
The container (3) for the Blender is
graduated for easy measurement and is
molded of heat and cold resistant material.
The convenient handle and pouring lip
permit easy removal of liquid mixtures
while thicker mixtures are more easily
removed through the bottom opening.
P A
ROCESSING SSEMBLY
The processing assembly consists of three
parts: a sealing ring (4) used as a cushion
between the container and the agitator;
an agitator (5) of high-grade stainless steel;
a threaded container bottom (6) .
M M B
OTOR AND OTOR ASE
The powerful multi-speed motor is the
heart of the appliance and is designed just
for this unit. It is completely enclosed
within the housing (7) . The motor uses a
"free-floating" feature to reduce noise and
wear. This allows the square post which
protrudes from the motor base to move
slightly from side to side. The powerful
food processing motor can be overloaded.
To avoid this possibility, closely follow the
instructions in this book.
O ® B
ST E R I Z E R L E N D E R
4
1
2
L
EFT
S
TOP
3
®
C
4
®
5
Do not attempt to place the container on or attempt to remove it from the motor base while
the motor is running.
A H
LWAYS OLD
6
CAUTION: Follow these important steps to assemble, tighten, and mount Blender container
quickly and correctly. INJURY MAY RESULT IF MOVING BLADES ARE EXPOSED.
1.
7
1. Turn container upside down so the small
opening is at the top.
2. Place sealing ring on container opening.
T C
I G H T E N I N G T H E O N TA I N E R
A. To tighten container bottom, put assembled
A B
container securely into motor base ring with
handle and lug in front of the right stop.
R
IGHT
B. Using container handle, turn container
S
TOP
to the left as far as possible. This insures
that the container bottom is tightened
C
ONTAINER
properly. Remove container from motor
L
UG
base and mount.
®
C. To operate Blender, place assembled
container in motor base ring with container
M
OTOR
lug against flat side of the motor base stop.
B
ASE
If container lug does not rest against flat
side of right stop, remove container
assembly and place against flat side of left
stop. Seat container firmly and operate.
D. To remove container, lift straight up.
(If it is not easily removed, rock gently and
D
lift up, do not twist). If container bottom
cannot be loosened by hand, place
assembled container into motor base ring
®
with handle in front of left side stop.
Using handle, turn container to right
until container bottom loosens.
C O H
ONTAINER WITH NE AND
A Y B
SS E M B L I N G O U R
2.
3. Turn the agitator blades upside down
and place in mouth of container.
4. Thread container bottom to container.
5
W P !
HILE ROCESSING
L E N D E R
3. 4.