Charging The Battery; Connecting The Power Supply And Battery Charger - Ottobock Genium X3 3B5-2 Instrucciones De Uso

• Android app "Cockpit 4X441-Andr=V*" for download from the website: http://www.ottobock-
group.com/cockpitapp
Accessories
The following components are not included in the scope of delivery and may be ordered separ­
ately:
• 3B5 4X900 protector
• 3B5 4X193-1 protector
• 3S26 cosmetic foam cover
• 4X350 Remote Control

6 Charging the battery

The following points must be observed when charging the battery:
• With average use, the capacity of the fully charged battery is sufficient for about 5 days.
• We recommend charging the product overnight when used on a daily basis.
• When used daily, the complete charging unit (power supply – battery charger) may remain
plugged into the wall socket.
• The battery should be charged for at least 3 hours prior to initial use.
• Use the 757L16* power supply and 4E60* battery charger to charge the battery.
• Note the permissible temperature range for charging the battery (see Page 92).
• The distance between the battery charger and the receiver on the product must not exceed
2 mm.

6.1 Connecting the power supply and battery charger

1
1) Slide the country-specific plug adapter onto the power supply until it locks into place (see
fig. 1).
2) Connect the round, three-pin plug of the power supply to the receptacle on the battery char­
ger (see fig. 2) so that the plug locks into place.
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the cable plug to the battery charger.
3) Plug the power supply unit into the outlet (see fig. 3).
→ The green LED on the back of the power supply lights up.
→ The LED ring (status indicator) on the rear of the charger lights up green to indicate the
correct connection to the power supply.
→ If the green LED on the power supply and the LED ring on the battery charger do not light up,
there is an error (see Page 87).
62 | Ottobock
2 3