Changing Prosthesis Settings - Ottobock Genium X3 3B5-2 Instrucciones De Uso

• Before the first step, always check whether the selected mode corresponds to the required
motion type.
Requirements for successful switching using motion patterns
The following points must be observed to carry out switching successfully:
• Position the prosthetic leg back slightly and bounce on the forefoot with the leg extended
while maintaining constant contact with the floor.
• Weight must be placed on the forefoot while bouncing.
• The load may not be taken off the foot fully when relieving the load.
Switching process
≥3x
ð
1) Position the prosthetic leg back slightly.
2) While maintaining constant contact with the floor and with the leg extended, bounce on the
forefoot at 3 times or more.
3) Keep the prosthetic leg still in this position with no load.
→ A beep and vibration signal will sound to confirm that the movement pattern has been
recognised.
INFORMATION: If this beep and vibration signal does not sound, the requirements
were not observed when bouncing the foot or mute mode (silent mode) is activ­
ated. For more information about mute mode, see the section "Mute mode" (see
Page 80).
4) After the beep and vibration signal sounds, keep the prosthetic leg extended and still for 1
second.
→ A confirmation signal will sound to indicate that the prosthesis has successfully switched over
to basic mode.
INFORMATION: If this confirmation signal does not sound, the leg with the prosthesis
was not correctly kept still or mute mode (silent mode) is activated. Repeat the pro­
cess to correctly switch to the required mode. For more information about mute mode,
see the section "Mute mode" (see Page 80).

8.3 Changing prosthesis settings

Once an active connection to a prosthesis has been established, the settings of the mode cur­
rently active can be changed using the cockpit app or the remote control (optional accessory).
For information on changing the prosthesis settings with the remote control (optional accessory),
see the remote control instructions for use.
INFORMATION
Bluetooth on the prosthesis must be switched on to change the prosthesis settings.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down or by
connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2
minutes. The connection must be established during this period.
Information for changing the prosthesis settings
• Before changing settings, always check the main menu of the cockpit app or the display of
the remote control (optional accessory) to make sure the correct prosthesis has been selec­
ted. Otherwise, parameters could be changed for the wrong prosthesis.
1x
ð
+
1x 1s 1x
ð ð
1x
ð
þ þ
Basic mode
+
Ottobock | 75