Idiomas disponibles
Idiomas disponibles
The assembled cleaner will look like this
drawing.
1-4
Attach hose holder
Position hose holder (B) onto handle by
matching tabs on rack with openings on
back of handle. Make sure bolts are
through holes.
1-7
Attach tool holder
Remove tool and taped screw from
holder. Insert projections on holder into
slots on back of cleaner.
4
All manuals and user guides at all-guides.com
1-2
Attach upper handle
Remove clean solution tank (upper tank)
from deep cleaner.
1-5
B
Place nuts in recessed areas on back
of hose holder. Hold each nut in place
while tightening each bolt securely
(from the front of the handle) with a
Phillips screwdriver.
Only two nuts are needed on this
model. The extra nut is not required but
has been provided for your conve-
nience.
1-8
Slide holder down into place. Insert
screw at (D) and tighten with a Phillips
screwdriver.
1-3
With cord hook (A) to back of deep cleaner,
push upper handle down onto lower han-
dle. Push bolts into holes on front of han-
dle. If bolts will not go through hole easi-
ly handle is not pushed completely
down.
1-6
When handle sections are completely
together, squeeze trigger (C) on upper
handle to snap trigger rod in place.
1-9
D
Replace clean solution tank (upper
tank) by positioning bottom first. Press
on tank handle to snap top of tank into
place.
A
C
