Idiomas disponibles
Idiomas disponibles
3-15
Snap clip back into position making sure
solution hose (N) is not pinched and
moves freely.
Cleaning carpeted
stairs
Read "Before you begin cleaning"
instructions on page 10.
1. Place handle in upright position.
Agitator brushes will not rotate while
handle is in upright position.
2. Fill clean solution tank with HOOVER
Deep Cleansing™ Detergent according
to instructions on pages 7 and 8.
3. Attach tool to end of hose.
4. Hose length may require that machine
be placed at the top of the stairs to
clean upper half of stairway and at bot-
tom of stairs to clean lower half.
To prevent machine from falling, use
extra caution when cleaning on stairs.
Do not place deep cleaner on stairs.
Do not point tools toward people or
pets.
3-17
5. Dry hands and plug deep cleaner into
a properly grounded outlet.
6. Turn deep cleaner ON. If necessary,
refer to "Before using tool" section to
remove air from system.
7. Pre-spray the carpeted stair by hold-
ing the tool about one inch above the
carpet and push it forward while press-
ing the trigger (equals one wet stroke).
8. Position tool against the riser and slightly
press it into carpet pile. Press the trigger and
pull the tool slowly over the carpet (second
wet stroke). Release trigger at end of stroke.
All manuals and user guides at all-guides.com
3-16
N
Replace recovery tank front panel (F).
Slide panel down until it snaps firmly
in place.
3-18
9. Lift tool, and position it against riser.
Pull tool slowly over carpet without
pressing trigger (dry stroke).
It is best to alternate wet and dry strokes
as described above. End with more dry
strokes to aid in faster drying of carpet.
10. Overlap strokes by 1/2 inch to help
prevent streaking.
To avoid saturating carpet, do not use
more than 4 wet strokes over any one
area. Always end with dry strokes.
If additional cleaning is necessary, wait
until the carpet is completely dry before
using the tool again.
11. Empty recovery tank when the motor
sound becomes higher pitched and
there is a loss in suction (see "Automatic
shut-off", page 7).
When finished cleaning, follow "After
cleaning" instructions on pages 9 and 10
and "After using tool" instructions on
pages 12 and 13.
F
Cleaning upholstery
Read "Before you begin cleaning"
Instructions on page 9.
Be sure to check the cleaning code on
your upholstery. Use your HOOVER
'SteamVac' deep cleaner only on
upholstery marked "W" or "W/S".
1. Place handle in upright position.
Agitator brushes will not rotate while
handle Is In upright position.
2. Fill clean solution tank with HOOVER
Deep Cleansing™ Detergent according
to instructions on pages 7 and 8.
3. Attach tool to end of hose.
Do not point tools toward people or
pets.
4. Dry hands and plug deep cleaner into
a properly grounded outlet.
3-19
5. Turn deep cleaner on. If necessary,
refer to "Before using tool" section to
remove air from system.
6. Gently press the tool onto the fabric.
Press the trigger and slowly pull the noz-
zle over the fabric.
7. Overlap strokes by 1/2 inch to help
prevent streaking.
Make additional strokes without pressing
the trigger to remove more moisture.
8. To clean in corners or creases, lift the
tool one-half inch from the fabric and
press the solution trigger.
9. Vacuum up the solution with the tool
without pressing the trigger.
Continued
13
