Idiomas disponibles
Idiomas disponibles
Fitting the camera
Fitting the camera
A
NOTICE! Beware of damage
Only use the screws supplied to mount the camera. Longer screws will
damage the camera.
➤ Guide the camera cable into the vehicle interior.
➤ Slide the camera into the camera bracket.
➤ Fasten the camera loosely using the two screws M3 x 6 mm in the slots (fig. e,
page 6).
➤ Provisionally align the camera, so that the lens is at an angle of approx. 50° to the
vertical axis of the vehicle (fig. f, page 7).
Establishing the electrical connection for the camera
I
NOTE
• Lay the camera cable so that, should you need to remove the
camera, you can access the plug connection between the
camera and the extension cable easily. This greatly facilitates the
disassembly.
• To minimise corrosion in the plug, apply a small amount of grease,
such as pin grease, in one of the plugs.
➤ Insert the camera cable plug into the socket for the extension cable.
➤ Screw on the plug connection of the connecting cables to protect against water
penetration (fig. g, page 7).
Aligning the camera
I
NOTE
To do this you must first install and electrically connect a monitor (see
schematic connection diagram fig. h, page 7).
➤ Align the camera using the image on the monitor to help you:
The monitor image should show the rear or the bumper of the vehicle at the
bottom edge of the screen. The middle of the bumper should be in the middle
of the screen (fig. i, page 7).
➤ Check the function of the camera after you have connected it to a monitor.
18
All manuals and user guides at all-guides.com
CAM45
EN
