Idiomas disponibles
Idiomas disponibles
CAM45
• Check beforehand that there is sufficient space on the other side for the drill head
to come out (fig. 2, page 4).
• If you are not sure about the location you have chosen, ask your vehicle
manufacturer or dealer.
I
NOTE
We recommend greasing the threads of the bolts to prevent corrosion.
To perform the installation, proceed as follows:
➤ Hold the camera at the chosen location and mark at least two different points for
the drill holes and the duct for the connection cable (fig. a, page 6).
➤ Using a hammer and centre punch, gently pre-punch the previously marked
points to prevent the drill head from slipping off.
Creating a through-hole for the camera connection cable (fig. b, page 6)
I
NOTE
If possible, use available openings, such as ventilation grilles, to feed the
connection cables through. If there are no existing ducts, you must drill
a hole of Ø 16 mm.
A
NOTICE! Beware of damage
Check beforehand that there is sufficient space on the other side for the
drill head to come out.
➤ Drill a hole with a Ø 16 mm at the previously marked duct.
➤ Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
Screw on camera using self-tapping screws (fig. c, page 6)
A
NOTICE! Beware of damage
Self-tapping screws may only be fastened to steel metal with a minimum
thickness of 1.5 mm.
➤ Drill the holes, with a Ø of 4 mm, at each of the markings.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw on the camera bracket using 5 x 20 mm self-tapping screws.
EN
All manuals and user guides at all-guides.com
Fitting the camera
17
