Hilti SIW 22T-A 3/4 Manual De Instrucciones Original página 17

5.1.9 Removing the accessory tool
3
SIW 22T-A / "
4
1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Remove the O-ring from the groove in the accessory tool.
3. Pull out the locking pin.
4. Remove the accessory tool from the square drive spindle of the power
tool.
5. Fit the locking pin.
6. To keep it safe, fit the O-ring back on to the accessory tool.
5.2 Work
5.2.1 Switching on
▶ Press the control switch.
▶ Speed of rotation is regulated by the distance the control switch is
pressed in.
5.3 Switching off
▶ Release the control switch.
6 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance
tasks!
Care and maintenance of the tool
• Carefully remove stubborn dirt.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning
agents containing silicone as these can attack the plastic parts.
Care of the Li­ion batteries
• Keep the battery free from oil and grease.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning
agents containing silicone as these may attack the plastic parts.
• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals
and make sure that they all function correctly.
• Do not operate the product if signs of damage are found or if parts
malfunction. Have it repaired immediately by Hilti Service.
*2153646*
7
2153646 English 11