Idiomas disponibles
Idiomas disponibles
6. MAINTENANCE AND CLEANING
6.1. DEFROSTING
Note: This unit does not have an auto defrost system.
Please use a plastic ice shovel when clearing the frosting of the evaporator. Do not use
metal sharp objects.
6.2. CLEANING THE INTERIOR AND THE EXTERIOR OF THE UNIT
■
Dusts behind the refrigerator and on the ground shall be timely cleaned to improve
the cooling effect and energy saving.
■
Check the door gasket regularly to make sure there are no debris. Clean the door
gasket with a soft cloth dampened with soapy water or diluted detergent.
■
The interior of the refrigerator should be cleaned regularly to avoid odor.
■
Please turn off the power before cleaning interior, remove all foods, drinks,
shelves, drawers, etc.
■
Use a soft cloth or sponge to clean the inside of the refrigerator, with two
tablespoons of baking soda and a quart of warm water. Then rinse with water and
wipe clean. After cleaning, open the door and let it dry naturally before turning on
the power.
■
For areas that are difficult to clean in the refrigerator (such as narrow sandwiches,
gaps or corners), it is recommended to wipe them regularly with a soft rag, soft
brush, etc. and when necessary, combined with some auxiliary tools (such as thin
sticks) to ensure no contaminants or bacterials accumulation in these areas.
■
Do not use soap, detergent, scrub powder, spray cleaner, etc., as these may
cause odors in the interior of the refrigerator or contaminated food.
■
Clean the bottle frame, shelves and drawers with a soft cloth dampened with
soapy water or diluted detergent. Dry with a soft cloth or dry naturally.
■
Wipe the outer surface of the refrigerator with a soft cloth dampened with soapy
water, detergent, etc., and then wipe dry.
■
Do not use hard brushes, clean steel balls, wire brushes, abrasives(such as
toothpastes), organic solvents (such as alcohol, acetone, banana oil, etc.), boiling
water, acid or alkaline items, which may damage the fridge surface and interior.
Boiling water and organic solvents such as benzene may deform or damage
plastic parts.
■
Do not rinse directly with water or other liquids during cleaning to avoid short
circuits or affect electrical insulation after immersion.
6.3. CLEANING TIPS
Condensation may appear on the interior surface of the unit. This may be due to a
change in room temperature. Wipe off any moisture residue. If the problem continues,
contact a qualified technician for assistance.
6.4. MAINTENANCE
Changing the internal light
Lamp replacement should only be made by a qualified technician.
Care when handling/moving your unit
Hold the unit around its sides or base when moving it. Under no circumstances should
it be lifted by holding the edges of the top surface.
Servicing
The unit should be serviced by an authorized engineer and only genuine spare parts
should be used. Under no circumstances should you attempt to repair the unit yourself.
Repairs carried out by inexperienced persons may cause injury or serious malfunction.
Contact a qualified technician.
15
EN
