Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
ENGINE AND SHAFT ASSEMBLY
Attach the clutch drum housing to the engine using the four screws.
HORN HANDLES
1. Loosen the four screws on the top of the clamp bracket.
2. Insert the left and right horn handles into the clamp bracket.
CONNECTING THROTTLE CABLE AND STOP
SWITCH WIRES
1. Insert the throttle cable through the cable adjuster sleeve.
2. Position the slotted fitting on the carburetor so the recessed
hole for the lug is away from the cable adjuster sleeve.
3. Rotate the carburetor throttle cam and slip the throttle cable
through the slot in the slotted fitting, making sure the cable
lug drops into the recessed hole.
4. Operate the throttle trigger a few times to make sure that it
works correctly.
5. Adjust the cable adjuster sleeve so the stop on the
carburetor throttle cam just contacts the throttle stop and
the cable position keep 1-2mm play between cable lug and
slotted fittings when the throttle trigger is fully depressed.
6. When the throttle cable is adjusted correctly, tighten the
lock-nut.
7. Plug the stop switch wires into the matching connectors from
the engine.
Note: That wire polarity is not important.
8. Clamp the throttle cable assembly with two bands as shown.
— US-3 —
Engine
Screw (4)
Clutch Drum Housing
Stop Switch Wires/
Throttle Cable
Handlebar
Clamp Bracket
Throttle Cable Housing
Cable Adjuster Sleeve
Lock Nut
Throttle Cable
Carburetor
Bracket
Slotted
Recessed Hole
Fitting
1-2mm Play
Stop Switch Wires
Band (2)
Screw (4)
Cable Lug
Throttle Cable
