Idiomas disponibles
Idiomas disponibles
Instructions for Use
Fig. 21
• Place a bowl at the drainage pipe outlet
and remove the plug to collect the
condensed water, Fig. 22.
Fig. 22
• Remove the diffusion duct and set the
air expulsion tube to the position shown
in figure 23.
• The expulsion tube may also be totally
dismantled if desired.
Fig. 23
• Lift the air director on the top of the
appliance. This air director is not
installed on the appliance on 3XM4.1E
models. See figures 26 and 27 in
"Heating".
• Plug the appliance into the mains
electricity supply.
• Set the control knob to the
dehumidification function depending on
the model of your air-conditioning
appliance.
Models with electric heating
models
.
All manuals and user guides at all-guides.com
; other
45
Fig. 24
Warning!
The amount of water dehumidified
may vary depending on ambient
conditions (See "Technical
Information").
Do not forget to replace the plug onto
the water drainage pipe when you
change function, otherwise the
appliance will shed water when
operated.
Remember that ambient temperature
must be 18ºC or higher in order for the
appliance to work.
In this operation function, room
temperature rises slightly.
Air purification
The air entering the room (ventilation) is
circulated through a purifying filter when
the appliance is set to this function
The appliance comes with a basic filter
(already fitted on the appliance) and a
purifying filter (except on models
3XM4..B) to be fitted by the user-See
"Fitting the purifying filter (double active)"-
against:
- Pollen, bacteria and dust.
• Put the air expulsion tube in the same
position as for dehumidification.
• Lift the air director on the top of the
appliance. This air director is not
installed on the appliance on 3XM4.1E
models. See figures 26 or 27 in
"Heating".
• Plug the appliance into the mains
electricity supply.
• Set the control knob to the air-
purification function
, Fig. 25.
