Idiomas disponibles
Idiomas disponibles
Requirements for use
Warning!
The mains electricity supply
connection cable must only be
replaced by authorised members of
the manufacturer's Official Technical
Service.
Remember that when the appliance is
turned off, it is necessary to wait for
approximately 3 minutes before
turning it back on again. This period
of time is required in order to ensure
correct appliance operation.
Avoid direct contact with the air
expelled through the expulsion tube.
Transportation requirements
The appliance is fitted with wheels to
make it easier to move around. If
necessary, you can tilt the appliance in
order to move it. You should not turn the
Instructions for Use
Preparing the appliance
Fitting the air expulsion tube and
accessories onto the appliance.
Fit the air expulsion tube onto the fixture
with the "push" tab and thread it anti-
clockwise, Fig. 8.
Fig. 8
Housing for the air
expulsion assembly
All manuals and user guides at all-guides.com
41
appliance back on again for a minimum
period of one hour after performing this
procedure.
• Before tilting it, empty the condensed
water from the internal tank by
extracting the water drainage pipe from
its housing and removing the plug, Fig.
7, Do not forget to replace the plug and
reinsert the pipe in its housing when
the tank is empty.
Fig. 7
If easier, the housing can also be
removed from the appliance by pressing
the "Push" tab and sliding it out, Fig. 9.
Fig. 9
Once out, thread the expulsion tube as
shown on Fig. 10, making sure that it is
properly secured.
