Idiomas disponibles
Idiomas disponibles
Power the Motor
The electrical supply must be a separate branch
DANGER
circuit with a properly sized breaker or fuses.
All wiring must conform to National (NEC),
CSA, state, provincial, and local codes. Power
supply voltage, phase and controls must match
Hazardous voltage
can shock, burn or
motor.
cause death.
NEVER RUN A PUMP DRY, DAMAGE WILL RESULT,
AND THE WARRANTY WILL BE VOIDED!
ALWAYS DISCONNECT AND LOCK-OUT
DANGER
ALL ELECTRICAL POWER WHEN IN-
STALLING OR WORKING ON PUMPS,
MOTORS, OR SWITCHES. INSURE THE
POWER SUPPLY BREAKER IS OFF OR THE
Hazardous voltage
can shock, burn or
cause death.
DISCONNECT (WHERE USED) IS OFF.
Remove the pressure switch cover. Attach the power
supply wires, either 115 or 230 depending on the motor
voltage, to the Line terminals of the pressure switch.
BOOSTER SYSTEMS
BOOSTER SYSTEMS
Use the basic instructions for either a Shallow Well or Convertible with Shallow Well Adapter. If a city water booster
system please plumb per Fig. 5
J, JS, JRS OR HSJ SERIES
UNION
BALL
VALVE
GAUGE
UNION
UNION
Use flow control or ball valve
PRESSURE
on suction to throttle pump. Must
be sized, or set, to load motor
below maximum nameplate amps.
Maximum inlet pressure should
be limited so discharge does not
exceed relief valve setting, or 100 psi
(0.68Pa) absolute maximum.
SEASONAL SERVICE
SEASONAL SERVICE
It is necessary to drain the entire system where the pump,
tank, and piping will be subjected to freezing. Vertical
pumps have a drain plug located on the side of the pump
casing near the bottom of the pump. Horizontal pumps
may have two drain plugs, one on the casing (part where
pipes attach) and another on the motor adapter. They are
also located near the bottom of the pump. Multi-stage
pumps also have 1 or 2 drain plugs and they may require
you to tip the pump or blow compressed air in one hole
to get all the water out of the stages.
WATER MAIN
CHECK
VALVE
TO SIZE TANK
GATE
VALVE
PROPERLY –
MATCH
DRAWDOWN
OF TANK TO
CAPACITY
OF PUMP.
RELIEF
VALVE
SWITCH
Fig. 5
Attach the green or bare ground wire to either green
ground screw in the switch. It makes no difference which
Line terminal you attach the hot- L1 (usually Black)
and neutral- N (usually white) 115 volt wires to on the
switch. The same goes for a 230 volt hook-up, either
wire can go on either Line terminal. Re-install the switch
cover. NOTE: Motor voltage is NOT changed in the
pressure switch. See Fig. 7 in Technical Data.
Check to insure that the motor is wired to match the
incoming voltage. All motors have a sticker near the
pressure switch that identifies the pre-wired voltage. All
½ hp jet pumps are factory wired for 115 V , and ¾ hp
and larger are wired for 230V . The motor voltage must
be changed inside the motor cover, not in the pressure
switch. Make sure the breaker or disconnect is OFF
before entering the motor cover. All motors have a wir-
ing diagram on the cover label and it is also found in this
manual. See Motor Wiring Diagram, Fig. 7, in Technical
Data.
If pumping from a cistern or water tank plumb
per Fig. 6.
MAIN POWER BOX
GATE
FUSE BOX
VALVE
OR
SWITCH
STORAGE TANK
GATE
HYDRO-
VALVE
PRO
JET PUMP
TANK
CHECK
VALVE
Fig. 6
7
